Radio Shack Boating Equipment 63 1120 User Guide

Digital Vehicle Compass  
63-1120  
OWNER’S MANUAL — Please read before using this equipment.  
Thank you for purchasing a RadioShack Digital Vehicle Compass.  
Your compass conveniently provides accurate heading  
information inside your vehicle. It incorporates the same magnetic  
sensor technology that is used in factory-installed vehicle  
compasses. The compass electronically separates the Earth’s  
magnetic field from the magnetic fields generated by your vehicle,  
to provide accurate compass headings.  
Automatic Shut-Off — conserves power by turning off the  
compass about 10 minutes after you park the vehicle when there  
are no significant changes in the surrounding magnetic fields.  
Magnetic Distortion Detection — alerts you when outside  
magnetic interference is affecting compass accuracy.  
INSTALLING BATTERIES  
Your compass requires two AAA batteries (not supplied) for  
power. For the best performance and longest life, we recommend  
RadioShack batteries. Battery life is about 11 months (based on  
an average of 8 hours of compass use and 2 hours of backlight  
use per week).  
Cautions:  
• Use only fresh batteries of the required size and  
recommended type.  
• Do not mix old and new batteries, different types of batteries  
(standard, alkaline, or rechargeable), or rechargeable  
batteries of different capacities.  
© 2001 RadioShack Corporation. All Rights  
Reserved.  
RadioShack and RadioShack.com are trademarks  
used by RadioShack Corporation.  
 
to positive and its plug must fit the compass' jack. Using an  
adapter that does not meet these specifications could  
damage the compass or the adapter.  
• Always connect the DC adapter to the compass before you  
connect it to the power source. When you finish, disconnect  
the adapter from the power source before you disconnect it  
from the compass.  
Note: Since not all vehicles have constant power supplied to the  
power outlet, two AAA batteries are required to retain the  
compass calibration settings in memory (although they do not  
power the compass when vehicle battery power is used).  
Insert the barrel plug of the 12V DC adapter (not supplied) into the  
DC12V jack on the back of the compass. Then insert the DC plug  
into your vehicle’s power outlet.  
MOUNTING THE COMPASS  
Choose a clean mounting location on the vehicle’s windshield  
where the compass is at least 5 inches away from any stereo  
speakers and will not obstruct the driver’s field of view.  
Your compass comes with three suction cups for secure  
mounting.  
1. Insert the small ball head of each suction cup into the larger  
hole on the bottom of the bracket and slide it into the  
bracket’s smaller hole so it fits tightly.  
2. Place the compass in the holder.  
Note: To remove the compass from the holder, simply slide it  
out.  
3
 
3. Firmly press  
the bracket  
with the  
compass  
against the  
vehicle’s  
windshield.  
4. Adjust the  
angle of the  
bracket so  
that the face  
of the compass points to the back of the vehicle. Then adjust  
°
the bracket to an angle no more than 20 above or below the  
horizontal plane.  
5. Tighten the bracket’s screw to hold it at the desired angle.  
Caution: If you use a reflective sun shade, do not leave the  
compass between the sun shade and the windshield. The  
extreme heat might damage the compass.  
Note: Your compass will not calibrate correctly and will not be  
accurate unless it is mounted so the display faces the back of your  
°
vehicle and is titled no more than 20 above or below the  
horizontal plane. The selected angle must stay fixed after  
calibration for the compass to remain accurate.  
CALIBRATING THE COMPASS  
Calibration enables the compass to separate the earth’s magnetic  
field from the magnetic fields generated by external influences  
(such as your vehicle) so it can provide accurate heading  
information.  
4
 
When calibrating the compass, you must drive your vehicle in one  
complete circle. Be sure your vehicle is on level ground in an open  
area, such as a parking lot.  
The size of the circle and the direction your vehicle points when  
beginning or ending the circle do not matter. The circle does not  
need to be perfect, but it must be completed within 2 minutes.  
Important: If you do not calibrate your compass properly, it will  
not work correctly or accurately. You must calibrate your compass  
when you use it the first time and recalibrate it anytime:  
• you move the compass to a different location  
• you adjust the bracket/display angle  
• you remove and replace the batteries  
DIST appears steadily  
• all the arrows flash  
1. Ensure the compass is securely mounted (see “Mounting the  
Compass” on Page 3).  
2. Hold down LIGHT and POWER at the same time until all  
arrows flash at the same time.  
Note: If you have just installed/replaced the batteries, all the  
arrows and digits briefly appear, then all the arrows flash at  
the same time and the backlight turns on. Begin from Step 3  
to calibrate your compass.  
3. Press POWER. The arrows appear one at a time.  
4. With the compass mounted, drive in one complete circle and  
then press POWER. The current compass heading appears.  
5
 
Note: If you press LIGHT while calibrating your compass (except  
after installing/replacing batteries), the compass does not store  
the calibration setting and the original setting is unchanged.  
USING THE COMPASS  
The 8 displayed cardinal points for this compass are N, NE, E, SE,  
S, SW, W, and NW.  
Distortion Detection  
When DIST appears, the compass is detecting magnetic  
interference that compromises its accuracy. Distortion occurs  
when there has been a significant change in the surrounding  
magnetic fields, such as when you are driving under an overpass,  
or over a bridge. The steel in these structures causes inaccurate  
readings in any magnetic compass, but unlike other compasses,  
this compass detects interference and alerts you.  
If DIST appears continuously, recalibrate your compass (see  
“Calibrating the Compass” on Page 4).  
Turning the Compass On and Off  
Press POWER to turn the compass on and off. Or, you can press  
LIGHT to turn on the compass and the backlight.  
To turn off the compass and the backlight, press POWER.  
Important: The compass automatically turns off after about 10  
minutes to conserve power if no significant changes occur in the  
surrounding magnetic fields.  
6
 
Using the Backlight  
To turn on the backlight, press LIGHT. To turn off the backlight,  
press LIGHT again.  
The backlight automatically turns off after about 1 minute if it is  
powered by internal batteries. It automatically turns off after about  
10 minutes if it is powered by vehicle battery power, unless  
significant changes occur in the surrounding magnetic fields.  
CARE  
Keep the compass dry; if it gets wet, wipe it dry immediately. Use  
and store the compass only in normal temperature environments.  
Handle the compass carefully; do not drop it. Keep the compass  
away from dust and dirt, and wipe it with a damp cloth  
occasionally to keep it looking new.  
Modifying or tampering with the compass’ internal components  
can cause a malfunction and might invalidate its warranty. If your  
compass is not performing as it should, take it to your local  
RadioShack store for assistance.  
SPECIFICATIONS  
Power ............................................................................................. 2 × AAA Batteries  
Optional 12V DC Adapter  
Sampling cycle ......................................................................................... 0.5 Second  
Display resolution ............................................................................................... 22.5°  
Accuracy ............................................................................................................... ±5°  
Storage temperature .................................................. – 40° to 160°F (– 40° to 71°C)  
Operating temperature ................................................. – 4° to 140°F (– 20° to 60°C)  
Dimensions (with bracket, HWD) ......................................... 25/8 × 23/4 × 23/4 Inches  
(66.0 × 69.9 × 69.9 mm)  
Dimensions (without bracket, HWD) ........................................ 21/2 × 21/2 × 1 Inches  
(63.5 × 63.5 × 25.0 mm)  
7
 
Weight (with bracket, without batteries) .............................................. 2.8 oz (79.4 g)  
Weight (without bracket and batteries) ................................................ 2.0 oz (56.7 g)  
Specifications are typical; individual units might vary. Specifications are subject to  
change and improvement without notice.  
Limited One-Year Warranty  
This product is warranted by RadioShack against manufacturing defects in material and work-  
manship under normal use for one (1) year from the date of purchase from RadioShack com-  
pany-owned stores and authorized RadioShack franchisees and dealers. EXCEPT AS  
PROVIDED HEREIN, RadioShack MAKES NO EXPRESS WARRANTIES AND ANY IMPLIED  
WARRANTIES, INCLUDING THOSE OF MERCHANTABILITY AND FITNESS FOR A PAR-  
TICULAR PURPOSE, ARE LIMITED IN DURATION TO THE DURATION OF THE WRITTEN  
LIMITED WARRANTIES CONTAINED HEREIN. EXCEPT AS PROVIDED HEREIN, Ra-  
dioShack SHALL HAVE NO LIABILITY OR RESPONSIBILITY TO CUSTOMER OR ANY  
OTHER PERSON OR ENTITY WITH RESPECT TO ANY LIABILITY, LOSS OR DAMAGE  
CAUSED DIRECTLY OR INDIRECTLY BY USE OR PERFORMANCE OF THE PRODUCT  
OR ARISING OUT OF ANY BREACH OF THIS WARRANTY, INCLUDING, BUT NOT LIM-  
ITED TO, ANY DAMAGES RESULTING FROM INCONVENIENCE, LOSS OF TIME, DATA,  
PROPERTY, REVENUE, OR PROFIT OR ANY INDIRECT, SPECIAL, INCIDENTAL, OR  
CONSEQUENTIAL DAMAGES, EVEN IF RadioShack HAS BEEN ADVISED OF THE POSSI-  
BILITY OF SUCH DAMAGES.  
Some states do not allow limitations on how long an implied warranty lasts or the exclusion or  
limitation of incidental or consequential damages, so the above limitations or exclusions may  
not apply to you.  
In the event of a product defect during the warranty period, take the product and the Ra-  
dioShack sales receipt as proof of purchase date to any RadioShack store. RadioShack will, at  
its option, unless otherwise provided by law: (a) correct the defect by product repair without  
charge for parts and labor; (b) replace the product with one of the same or similar design; or (c)  
refund the purchase price. All replaced parts and products, and products on which a refund is  
made, become the property of RadioShack. New or reconditioned parts and products may be  
used in the performance of warranty service. Repaired or replaced parts and products are war-  
ranted for the remainder of the original warranty period. You will be charged for repair or re-  
placement of the product made after the expiration of the warranty period.  
This warranty does not cover: (a) damage or failure caused by or attributable to acts of God,  
abuse, accident, misuse, improper or abnormal usage, failure to follow instructions, improper  
installation or maintenance, alteration, lightning or other incidence of excess voltage or cur-  
rent; (b) any repairs other than those provided by a RadioShack Authorized Service Facility;  
(c) consumables such as fuses or batteries; (d) cosmetic damage; (e) transportation, shipping  
or insurance costs; or (f) costs of product removal, installation, set-up service adjustment or re-  
installation.  
This warranty gives you specific legal rights, and you may also have other rights which vary  
from state to state.  
RadioShack Customer Relations, 200 Taylor Street, 6th Floor, Fort Worth, TX 76102  
12/99  
63-1120  
RadioShack Corporation  
Fort Worth, Texas 76102  
01A02  
Printed in China  
 

Radio Shack Baby Toy 60 2809 User Guide
RCA Cell Phone M72 User Guide
RCA MP3 Player SL5004 User Guide
Remotec Universal Remote 1279041 User Guide
Ryobi Trimmer RY15525 User Guide
Sanyo Projection Television HT27745 User Guide
Sanyo Vacuum Cleaner SC 270 User Guide
Sears Saw 2043699969 User Guide
Seiko Watch 5J22 User Guide
Senco Nail Gun E XP Series User Guide