Sanyo Vacuum Cleaner SC X2015N User Guide

Trouble shooting  
If you have a problem with your cleaner, consult the handy guide below. If the cleaner  
is malfunctioning, do not operate it and please ask for service.  
Problem  
Possible cause  
Possible solution  
Instrcution Manual  
Vacuum Cleaner  
SC-X2015N  
Cleaner won’t run  
Low suction  
1.Not firmly plugged in  
1.Plug unit in firmly  
1.Clogged floor brush,  
hose or tube  
1.Remove the blockage  
2.Empty the dust cup  
2.Full of dust in the dust cup 3.Put the dust cap in place  
3.Dust cup not in place  
4.Clogged the filter  
4.Clean or replace the filter  
1.Pull out the cord and rewind  
Cord doesn’t fully rewind  
1.Cord twisted or uneven  
Technical specification  
Rating Voltage  
230-240V  
50Hz  
1800-2000W  
Power  
Rating Frequency  
Power Cord Length  
Dust Capacity  
1.5L  
4.5m  
7
 
·
·
Combination nozzle  
·
Do not pick up anything that is burning or smoking, such as cigarettes,  
matches, or hot ashes.  
Use crevice nozzle to vacuum edges and gaps. (Figure 12)  
The head of the combination nozzle can rotate. Use the round brush to  
vacuum sofa, curtain or fragile or easily scratched items.  
Dust cup  
·
·
·
·
Do not use without filters in place.  
Turn off all controls before unplugging.  
Use extra care when cleaning on stairs.  
1.Empty the dust cup before contents reach the Max mark. (Figure 13)  
Do not use to pick up flammable or combustible liquids such as gasoline or  
use in areas when they may be present.  
12  
2.Press the dust cup clamp ( ) and pull the cup out. (Figure 13)  
13  
3.Press the release button ( ) to open the trapdoor and empty the dust.  
·
Hold plug when rewinding onto cord reel. Do not allow plug to whip when  
rewinding.  
(Figure 14)  
·
·
Avoid using in a vertical position.  
If the supply cord of this appliance is damaged, ask the shop which you  
bought, or it must only be replaced by properly qualified service personnel  
because a special purpose tool is required.  
·
If you find the motor temperature too high or any unusual noise when using,  
stop the operation and do not open the appliance.  
7
9
8
13  
12  
1
2
Care and cleaning  
Caution: Be sure to turn the power off and unplug the unit before cleaning.  
Note: To maintain maximum cleaning performance, empty the dust cup, clean  
the filters often and replace outlet filters as needed.  
SAVE THESE INSTRUCTIONS  
This vacuum cleaner is intended for household use only.  
·
Clean HEPA filter  
1.Empty the dust cup.  
23  
2.Reverse the dust cup and turn the outlet filter cover ( ) several times in the  
direction shown and pull it out. If necessary, remove the dust jammed in the  
HEPA filter. (Figure 15)  
2
5
 
Name of parts  
How to assemble/disassemble  
·
To connect hose, press the button on the hose end and insert the hose into  
1
the opening until the hose locks. To detach, press the button ( ) on the  
5
21  
2
hose end and pull the hose toward you. (Figure 4)  
·
·
To connect hose ( ) with telescopic tube ( 3 ), insert the hose into the tube  
2
3
and rotate until firmly connected. (Figure 5)  
7
4
20  
Put the floor brush ( ) or the combination nozzle into the tube ( ) and  
3
8
rotate to connect them firmly. (Figure 6)  
9
2
3
5
10  
11  
5
20  
6
3
4
5
6
How to use  
19  
20  
·
Plug and power cord  
12  
13  
23  
22  
16  
Important: The power cord ( ) has a yellow marking and a red  
marking. Up to yellow marking is the recommended length.  
Never pull the cord beyond the red marking. (Figure 7)  
Before starting operation, pull out the power cord and connect the plug.  
After using, be sure to disconnect the plug and rewind the power cord.  
To rewind the power cord, step the cord rewind pedal at the rear of the  
cleaner. Before rewinding, be sure the cord is unplugged (Figure 8)  
ON/OFF switch  
18  
14  
MAX  
24  
17  
16  
15  
·
·
Press the ON/OFF switch on the top of the cleaner to start or stop operation.  
(Figure 9)  
Variable Power  
To control suction power, slide the speed regulator knob on the body.  
Slide up to the upper end for maximum power. Slide down to the lower end  
for minimum power. (Figure 10)Suction power can also be controlled  
2
1
by sliding the air flow regulator ( )on the hose ( ). Slide up to the  
upper end for maximum power. Slide down to the lower end for minimum  
power. (Figure 11)  
3
4
 

Quasar Camcorder VM D101 User Guide
RCA Car Video System DRC97983 User Guide
Rosen Entertainment Systems GPS Receiver DS UN0910 User Guide
Samson Headphones CM20P User Guide
Samsung Cell Phone DFX 5000 User Guide
Samsung CRT Television CL28A20HE User Guide
Samsung MP3 Player YP T7J User Guide
Sanyo Griddle HPS SG4 User Guide
Sears Humidifier 75814417 User Guide
Sears Water Pump 390304692 User Guide