Roadmaster 12 Subwoofer VSW120 User Manual

Installation  
Frequently Asked Questions  
VSW120  
12Subwoofer  
What if there is no sound?  
Speaker wire of 18 Gauge to 12 Gauge may be used with the VSW120C. You can  
purchase speaker wire with spade lug type female disconnects pre-installed on one end.  
1. Your stereo may have a blown fuse.  
Replace fuse with the same amperage and style.  
2. You may have improper wiring.  
Read First!  
Refer to the wiring guide that came with your stereo/amplier. Check all wires for a secure  
connection.  
Wiring  
Dear Customer,  
To attach speaker wires (not  
included) with female quick  
connects (spade lug type) to  
the speaker terminals.  
Subwoofer Terminals  
CONGRATULATIONS. The VSW120 Subwoofer, when used as described, will give you years  
of dependable service in your car, truck, RV or mini-van. We have taken numerous measures  
in quality control to ensure that your product arrives in top condition, and will perform to your  
satisfaction. In the rare event that your VSW120 Subwoofer contains a damaged or missing  
item, does not perform as specied, requires warranty service or you have an installation  
problem, DO NOT RETURN THIS PRODUCT TO THE STORE. PLEASE CALL OUR TOLL  
FREE NUMBER FROM THE U.S.A. AND CANADA (800-445-1797) and ask to speak with  
a member of our technical service team, or submit your questions by e-mail our web site  
vr-3.com, and a member of our technical service team will respond by e-mail to your ques-  
tions. Our in-house technical service team will expedite delivery of your part, advise you on  
installation, or help troubleshoot a problem with you. If your product needs warranty service,  
our technical service team representative will help you obtain the fastest remedy possible  
under the warranty.  
What if the sound volume is low?  
Your stereo may not have enough power, you may have to install an amplier to drive a  
subwoofer.  
Push  
the  
female  
quick  
connects (spade lug type) onto  
the terminals. Maintain proper  
polarity by attaching the Posi-  
tive Wire (+) to Positive Termi-  
nal (+) and the Negative Wire (-)  
to Negative Terminal (-).  
Why do I have a whining noise coming from the subwoofer?  
You may have poor ltering of your alternator. If that is the case, then you may need to add  
an alternator lter to the power lead.  
Why do I have odd sounding noises coming from the subwoofer?  
You may have corroded battery terminals and/or a weak battery. If the terminals on the  
battery are corroded, clean them; then check the sound. If the sound system is still making  
noises check battery strength. If it is low recharge or replace the battery.  
If the female quick connects  
can be easily pulled off, they  
can be tightened a little bit by  
lightly squeezing them with  
a pair of pliers. Do not atten  
them completely.  
Notes  
Specications  
• 12” Embossed Polypropylene Cone  
• 26.5 oz. Magnet Weight ±10%  
• Black Rubber Surround  
Wires from Amplifier  
Installing in a Enclosure  
• 35 to 2000 Hz Frequency Response  
• 2” ASV, Dual Voice Coil  
• Impedance 4 Ohms +/- 15%  
• Sensitivity 89db 1W/1M Minimum  
• Quick Connect Terminals (Spade Lug Type)  
The VSW120 is designed to give you optimum bass performance when installed in a  
sealed speaker enclosure.  
• 400 Watts Maximum Peak Power  
• 40 watts RMS per Voice Coil  
Before installing in an enclosure use the VSW120 as a guide to mark the enclosure  
for pilot holes. When you have marked the pilot hole positions drill them with a bit  
that is smaller than the screws you will use to secure the speaker to the enclosure.  
Before You Install  
Automotive audio equipment installations can be troublesome at times, even to the  
most experienced of installation technicians. If you are not condent working with  
electrical wiring, removing and reinstalling interior panels, carpeting, dashboards or  
other components of your vehicle, please call our toll free help line (800) 445-1797  
and our in-house technical service team will answer your installation questions.  
Most car stereos do not have enough power to drive separate subwoofers, if your  
mobile auto audio system does not have a separate amplier installed, you will most  
likely need to install one.  
Attach the positive (+)  
and negative (-) wires  
Place the subwoofer  
into the opening of the  
enclosure. Then align  
the screw holes of the  
subwoofer with the pilot  
holes that you drilled.  
Tighten the screws.  
Place a subwoofer grill  
(optional) over the sub-  
woofer, then fasten the  
subwoofer grill in place.  
Attach wires from audio  
source to the terminals  
on back of the enclo-  
sure.  
Before permanently installing the VSW120 speakers in your car, connect the wires  
to the speakers according to your audio systems installation manual, in the approxi-  
mate location you will install them. If you are satised with the location proceed with  
the permanent installation.  
found  
inside  
the  
enclosure box to the  
VSW120 terminals. At-  
tach Positive (+) to posi-  
tive (+), and negative (-)  
to negative (-).  
Limited Warranty  
Seal the hole with silicone  
caulking where the wire  
VIRTUAL REALITY VIDEO LABS® products are designed and manufactured to provide a high level of trouble-free per-  
formance. VIRTUAL REALITY VIDEO LABS® warrants, to the original purchaser, that its products are free from defects  
in material and workmanship for 30 days from the date of original purchase, as part of our commitment to product  
excellence. VIRTUAL REALITY VIDEO LABS® and/or its afliates routinely improves the designs, materials or produc-  
tion methods of its existing products. Because it is impractical to publicize all changes in every product, we reserve the  
right to make such changes without notice.  
passes through the side of  
the speaker box.  
If you are building your own sealed  
5/8” thick  
particle board  
or M.D.F.  
box enclosure, it should have a vol-  
ume of 1.5 to 2.0 cubic feet, and  
made with a minimum of 5/8” thick  
particle board or M.D.F.. Make  
sure that you screw and glue it to-  
gether for a proper seal, caulk all  
seams, and joints with silicone rub-  
ber caulking. The inner walls of the  
enclosure should be covered with a  
sound absorbing material. Maintain  
polarity of the amplier and speak-  
er for proper phase alignment. This  
insures the VSW120 operates at  
maximum efciency.  
Give Us A Call, We’ll Help You Install  
CONDITIONS OF WARRANTY:  
If during the 30 day warranty period your new product is found to be defective, VIRTUAL REALITY VIDEO LABS® will  
repair such defect, or replace the product, without charge for parts or labor subject to the following conditions:  
1. All repairs must be performed by VIRTUAL REALITY VIDEO LABS® and/or its afliates in Eatontown, New Jersey.  
2. The equipment must not have been altered or been damaged through negligence, accident, or improper operation.  
3. The replacement of parts are exempted from this warranty when replacement is necessary due to normal wear and tear.  
4. All warranty claims must be accompanied by a copy of the sales receipt or bill of sale.  
5. Repair or replacement parts supplied by VIRTUAL REALITY VIDEO LABS® under this warranty are protected only for  
the unexpired portion of the original warranty.  
GIVE US A CALL, WE'LL HELP YOU INSTALL.  
PLEASE DO NOT RETURN PRODUCT TO STORE.  
Visit us on the WEB  
6. In the case of car stereos, this warranty does not extend to the elimination of car static or motor noise; correction of  
antenna problems; costs incurred for the removal or reinstallation of the product; damage to tapes, speakers, acces-  
sories or car electrical systems.  
7. VIRTUAL REALITY VIDEO LABS® will not be responsible for any charge incurred for installation.  
For Information and Technical Assistance,  
Call Toll-Free in U.S.A. and Canada.  
Cover all inside walls of the enclosure  
with a sound deadening material such  
as Dacron batting.  
OWNER’S RESPONSIBILITIES:  
VIRTUAL REALITY VIDEO LABS® will make every effort to provide warranty service within a reasonable period of  
time.  
1-800-445-1797  
SHOULD YOU HAVE ANY QUESTIONS ABOUT SERVICE RECEIVED, OR IF YOU WOULD LIKE ASSISTANCE IN OB-  
TAINING SERVICE, PLEASE CALL TOLL FREE 1-800-445-1797, 8:30am - 4:30pm EST.  
In order to provide you with the proper warranty service, we request that you adhere to the following procedure:  
1. Include a copy of your sales receipt or bill of sale with your unit when it is returned for warranty service.  
2. If it is necessary to return your product for service, please return it securely packed, preferably in the original shipping  
carton, and freight and insurance prepaid to the following address: VIRTUAL REALITY VIDEO LABS, Service Depart-  
ment, 41 James Way, Eatontown, New Jersey 07724.  
Location Of Subwoofers  
Recommendations for Positioning the VSW120 in Your Vehicle:  
Tools Needed to Install  
3. Please include a detailed explanation of the problem you are having.  
4. If your product is found by VIRTUAL REALITY VIDEO LABS® to have a defect in material or workmanship, within  
the warranty period, it will be repaired or replaced at no charge and returned to you prepaid. Where permitted by Iaw  
VIRTUAL REALITY VIDEO LABS® liability shall be limited to that set forth in this warranty. This warranty shall be the  
exclusive remedy of the purchaser.  
Cars: Hatch Back or Trunk  
SUVs: & Mini Vans: Cargo Area  
Pick-up Trucks: Behind Front Seat  
• Marker/Pen  
• Wire Cutter  
• Nail Set/Center Punch  
• Phillips Screwdriver  
Virtual Reality Sound Labs® makes no other warranty of any kind, expressed or implied; and all implied warranties, are  
hereby disclaimed by Virtual Reality Sound Labs® and excluded from this warranty, Virtual Reality Sound Labs®, the  
manufacturer, distributor and seller shall not be liable for any injury, loss or damage, incidental or consequential, arising  
out of the use or intended use of the product  
All auto audio components must be securely mounted. Driving styles and  
road conditions such as sudden stops, sharp curves, and bumpy roads may  
cause unsecured items to move about the vehicle, causing physical injuries  
to vehicle occupants and/or vehicle damage.  
• Electric Drill  
with 1/16" bit  
• Hammer  
• Safety Glasses  
• Electrical Tape  
©2008 Intellectual Solutions, Inc., All Rights Reserved. All designs, logos and images are the exclusive property of Intellectual Solutions Inc.  
and/or its aflantes. US and Foreign Patents Pending. 071608 Printed in China 00000  

Radio Shack SYSTEM 2100 User Manual
QSC Audio Car Amplifier CMX500V User Manual
PYLE Audio PLAM1000 User Manual
Plantronics Explorer 320 User Manual
Philips VidQuad Color Video Processors TC8278 User Manual
Panasonic AG DVX100B User Manual
Meyer Cable Box 8118 User Manual
LG Electronics Chocolate 8500 User Manual
Legacy Car Audio LA780 User Manual
Kenwood DPX MP4050 User Manual